130° Ridge Flashings – Plastisol Paint Finish – 3m (200mm x 200mm)

Premium 3m Ridge Flashings with Plastisol Coating

Our 3-metre Ridge Flashings are precision-formed from galvanised steel and finished with a hard-wearing PVC plastisol coating. Designed to cap the apex of a pitched roof, they close the joint where both roof slopes meet and provide a clean, weathertight seal at the highest and most exposed point of the structure.

Each flashing is folded to a 130° internal angle with around 10–15° of flex, so it adapts to a wide range of roof pitches on site. A 10mm safety welt runs along each edge for added rigidity and safer handling during installation.

Key Features

• Manufactured from galvanised steel for long-term durability
• PVC plastisol finish for tough weather and corrosion resistance
• 130° internal angle with 10–15° flex to suit roof pitch
• Safety welt on all edges for strength and safer handling
• 3-metre length — allow at least 150–200mm overlap between consecutive lengths
• Wider 200mm x 200mm profile for good coverage over the ridge line
• Fix through the sheet crowns with stitcher / tek screws (sold separately)

Compatible with 13/3 corrugated, 32/1000 box profile, and 34/1000 box profile roofing sheets. For the best seal, pair with matching foam fillers at the ridge.

Please note: Nominal size is 200mm x 200mm. Actual cover is approximately 195mm x 195mm once the safety welt is accounted for. A clear protective film is applied during manufacture — remove after installation, or before prolonged exposure to sunlight or moisture.

Need a different angle or leg size? We also manufacture bespoke ridge flashings to your measurements. Contact us or call 01912 853848.